Registration Dossier
Registration Dossier
Please be aware that this old REACH registration data factsheet is no longer maintained; it remains frozen as of 19th May 2023.
The new ECHA CHEM database has been released by ECHA, and it now contains all REACH registration data. There are more details on the transition of ECHA's published data to ECHA CHEM here.
Use of this information is subject to copyright laws and may require the permission of the owner of the information, as described in the ECHA Legal Notice.
EC number: 253-634-7 | CAS number: 37697-65-7
Endpoint summary
Administrative data
Description of key information
The substance, 1-methyl-N,N’',N’’'-tris(1-methylpropyl)silanetriamine is not stable in water, which affects the approach to the determination of physicochemical properties.
1-Methyl-N,N’',N’’'-tris(1-methylpropyl)silanetriamine is a liquid at standard temperature and pressure, with a measured melting point of <-100°C, and a measured boiling point of 245°C. It has a measured relative density of 0.841 at 20°C, a kinematic viscosity value of 2.8 mm2/s at 20°C. It is not expected to be surface active. The substance has a measured vapour pressure of 2.9 Pa at 20°C and 29 Pa at 50°C.
The substance is classified for flammability according to Regulation (EC) No. 1272/2008 on the basis of a flash point of 55.5± 0.5°C at 1013 hPa and a measured boiling point of 245°C. It has a measured auto-ignition temperature of 207°C at 972 -977 hPa, and is not explosive and is not oxidising on the basis of structural examination.
In contact with water, 1-methyl-N,N’',N’’'-tris(1-methylpropyl)silanetriamine hydrolyses very rapidly (half-life <2 minutes at pH 4 and pH 7 and 25°C and 5 minutes at pH 9 and 25°C) to produce methylsilanetriol (1 mole, CAS No. 2445-53-6) and sec-butylamine (3 moles, CAS No. 13952-84-6) according to the following equation:
CH3Si(NHC4H9)3 + 3H2O → CH3Si(OH)3 + 3C4H9NH2
Therefore, the requirements for testing of water-based physicochemical properties for the substance are waived on the basis of instability in water. The properties of the silanol hydrolysis product, methylsilanetriol and sec-butylamine are assessed instead.
Sec-butylamine has a reported water solubility of 1.1E+05 mg/L at 20°C (Yalkowsky 1992), has low log Kow of 0.74 (Hansch et al. 1995) and a vapour pressure of approximately 24000 Pa at 25°C (Daubert and Danner 1989). The reported pKa of 10.6 (Perrin 1965) indicates that it has the potential to protonate when in the environment and will exist almost entirely in cationic form while in the environment.
The silanol hydrolysis product, methylsilanetriol, may undergo condensation reactions in solution to give siloxane dimers, linear and cyclic oligomers and highly cross-linked polymeric particles (a colloidal suspension of small solid particles known as a sol) that may over time form an insoluble gel and a dynamic equilibrium is established. The overall rate and extent of condensation is dependent on nominal loading, temperature, and pH of the system, as well as what else is present in the solution.
The condensation reactions of silanetriols may be modelled as an equilibrium between monomer, dimer, trimer and tetramer, with the linear tetramer cyclising to the thermodynamically stable cyclic tetramer. At higher loadings, cross-linking reactions between the cyclic tetramers may occur. The reactions are reversible unless the cyclic tetramer concentration exceeds its solubility; in this case, the cyclic tetramer forms a separate phase, driving the equilibrium towards the tetramer. At loadings below 500 mg/l of methylsilanetriol, the soluble monomer is expected to predominate in solution (>99%), with small amounts of dimer and oligomers. Condensation reactions are expected to become important at loadings above about 1000 mg/l causing the formation of insoluble polymeric particles and gels over time. Further information is given in a supporting report (PFA 2016am) attached in Section 13.
The saturation concentration in water of the silanol hydrolysis product methylsilanetriol is therefore limited by condensation reactions to approximately 1000 mg/l. However, it is very hydrophilic (calculated solubility is 1E+06 mg/l at 20°C using a QSAR method) with a predicted low log Kow of -2.4. It is not surface active. The silanol hydrolysis product is much less volatile than the parent substance (predicted vapour pressure = 5.3E-02 Pa at 25°C).
References:
Daubert, T.E., R.P. Danner (1989). Physical and Thermodynamic Properties of Pure Chemicals Data Compilation. Washington, D.C.: Taylor and Francis
Hansch, C., Leo, A., D. Hoekman (1995). Exploring QSAR - Hydrophobic, Electronic, and Steric Constants. Washington, DC: American Chemical Society., 1995., p. 10
PFA (2016am). Silanols and aquatic systems. Reference 404.105.003
Perrin D D (1965). Dissociation constants of organic bases in aqueous solution. IUPAC Chem Data Ser, Buttersworth, London.
Yalkowsky SH, Dannenfelser RM (1992). The AQUASOL dATAbASE of Aqueous Solubility. Fifth Ed, Tucson, AZ: Univ Az, College of Pharmacy
Additional information
Information on Registered Substances comes from registration dossiers which have been assigned a registration number. The assignment of a registration number does however not guarantee that the information in the dossier is correct or that the dossier is compliant with Regulation (EC) No 1907/2006 (the REACH Regulation). This information has not been reviewed or verified by the Agency or any other authority. The content is subject to change without prior notice.
Reproduction or further distribution of this information may be subject to copyright protection. Use of the information without obtaining the permission from the owner(s) of the respective information might violate the rights of the owner.
